HelpPages

Home | config

config

The following describes the steps necessary to configure the POS to the needs of the end user.

1. Hardware.
  - Windows
  For installation on Windows, there is no precise specification.
  - Linux
  The flash drive is configured to automatically installing it on a PC with a single hard drive and no optical drive. The configuration screen is optimized for Widescreen, although it will readjust pretty well for conventional displays. She will need a keyboard for the installation and registration.

2. Installation.
  - Windows
  Run setup like any Windows-based PC. If you want an automatic startup, place a shortcut icon Start.
  - Linux
  Start the POS connected with the stick of installation, and then boot from the flash drive, selecting the boot device in the BIOS. If you use the stick "netinstall" network must have automatic DHCP configuration with dynamic assignment of DNS. This is the most extended configuration. If your network has a configuration with proxies or not automatic, requires a USB flash drive for local installation.
  The installation takes ten to fifteen minutes depending on the bandwidth or power of POS.

.- Registry.
  When you start the POS for the first time, you are asked a registration key. You can get it at http://dealers.dsoft.es

4. Select Printer.
  Select your printer from the following options panel.

5. Set the user data. These are:
  Name.
  Street address
  NIF
  Sellers (separated by commas)
  Password Manager
  (Windows only) Printer Name (if not default).
  (Linux only) Parallel Printer. This box should only be marked with "S" if your printer is connected to the parallel port.